If the pitch trace of a signal is not visible or partly visible, LEFT CLICK that track's Display's Scaling Selector and select Pitch as shown top right in image below.

APT Energy being scaled down

LEFT CLICK the gray Pitch Scale Offset control (shown below selected by the mouse cursor) and move it up or down (or use the mouse wheel when the cursor is hovering in the track display) to bring the pitch trace into view. If the SHIFT key is held down at the same time, the same offset will be applied to all the tracks). This action does not change the pitch of the signal, it only slides the range of pitches displayed in the window.

APT- Result with wrong pitch limit

As shown in example above - the pitch trace can now be seen in the Guide track window. In this example, it is not yet correct as will be explained in the next section.


If you know the range is correct, you can jump to the instructions on: Alter the display to show pitches


Next topic: Pitch range