To select the Tilt operation, first make sure the H (horizontal time) lock is not ON. Select the right or left edge of a pitch group (as shown below) and an inward pointing arrow will appear.


For Mac, hold down the ALT key, LEFT CLICK and hold down the mouse button.


For Windows, LEFT CLICK and hold down the mouse button, and then press and hold the CTRL key.


A white line will appear attached to the anchor point (white dot) at the opposite end of the block. This line will show the tilting that takes place as the mouse is dragged up or down.


In the example below, the mouse is dragged down in the second picture, which levels out the rising pitch contour in the block.

Tilting Pitch BeforeTilt Pitch Group After